Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Programmer- AutoMind Programmer - Manual (Page 13)

97270 v.4.0
13
The diagnostic feature on the Banks
AutoMind programmer allows
you to read and clear Diagnostic
Trouble Codes (DTCs) and aids in
Troubleshooting.
1.
Plug the OBD II connector from your
Banks AutoMind programmer into the
OBDII connection port of your vehicle.
2.
After the welcome screen, scroll
up or down in the main menu screen
and highlight to select ‘ADDITIONAL
FEATURES’ and press the ‘OK’ button.
See Figure 7.
3.
Scroll through the ‘ADDITIONAL
FEATURES’ screen using the up and
down button keys to view the options.
4.
Highlight ‘Diagnostics’ and press
the ‘OK’ button.
5.
Highlight to select ‘Read DTCs’ and
press the ‘OK’ button. See Figure 8.
6.
Follow the on screen instructions
and turn the ignition key ‘ON’ when
prompted by the programmer, but do
not start the engine. Then press the
‘OK’ button.
7.
Scroll up or down to view
any displayed DTC along with a
description. Press the ‘Left’ button to
EXIT.
8.
To remove Diagnostic Trouble
Codes (DTC) press the ‘OK’ button to
return to the ‘Diagnostics’ menu and
scroll down to ‘Clear DTCs’. Press the
‘OK’ button. See Figure 9.
9.
Follow the on screen instructions
and turn the ignition key ‘ON’ when
prompted by the programmer, but do
not start the engine. Then press the
‘OK’ button.
10.
Screen will announce that the
DTCs have been cleared. Follow the
on screen instructions and turn the
ignition key OFF, when prompted by
the programmer. Then press the ‘OK’
button to EXIT and go to the previous
menu.
-END, SECTION 6-
Section 6
DIAGNOSTICS
Figure 7
Figure 8
Figure 9