Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Programmer- AutoMind Programmer User Manual
Page 2
2
97270 v.4.0
Dear Customer,
If you have any questions
concerning the use of Banks
AutoMind Programmer, please
call our Technical Service Hotline
at (888) 839-2700 between 7:00
am and 4:00 pm (PT). If you have
any questions relating to shipping
or billing, please contact our
Customer Service Department at
(888) 839-5600.
Thank you.
1.
Before starting work, familiarize
yourself with the installation procedure
by reading all of the instructions.
2.
Refer to each step and section
diagram in this manual for proper
instruction.
3.
Throughout this manual, the
left side of the vehicle refers to the
driver side, and the right side to the
passenger side.
4.
Ensure the vehicle battery is in
a fully charged state and all voltage
draining electrical equipment is in the
OFF position during Banks AutoMind
Programmer installation.
5.
Save this Owner’s Manual as a
reference for system maintenance and
service.
Introduction
Banks AutoMind Programmer is
designed to recalibrate the factory
Engine Control Module (ECM) in order
to optimize vehicle performance
based on your specific needs. The
AutoMind Programmer will store your
factory calibration and install the Banks
calibration of your choice, easily and
in minutes. Features include multiple
power levels (diesel), octane specific
calibrations (gas), On-Board Diagnostics
(OBDII) interface for reading and clearing
codes, monitoring for over 20 sensor
values, and acceleration performance
recording (1/4 mile, 0-60 mph, etc.).
Follow the instructions to complete the
Banks AutoMind calibration process and
get ready to enjoy Banks Power!
Table of Contents
Introduction . . . . . . . . . . . . . . . . . 2
Section 1 . . . . . . . . . . . . . . . . . . . . 3
Legal & Warranty Information
Section 2 . . . . . . . . . . . . . . . . . . . . 5
End User License Agreement (EULA)
Section 3 . . . . . . . . . . . . . . . . . . . . 7
Preparing Vehicle & Connecting Banks
AutoMind Programmer
Section 4 . . . . . . . . . . . . . . . . . . . . 9
Installing Banks AutoMind Calibration
Program
Section 5 . . . . . . . . . . . . . . . . . . . 12
Restoring Factory Calibration
Section 6 . . . . . . . . . . . . . . . . . . . 13
Diagnostics
Section 7 . . . . . . . . . . . . . . . . . . . 14
Data Logging
Section 8 . . . . . . . . . . . . . . . . . . . 15
Info & Settings
Section 9 . . . . . . . . . . . . . . . . . . . 16
TroubleShooting
General Installation Practices