Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Programmer- AutoMind Programmer - Manual (Page 7)

97270 v.4.0
7
Follow the vehicle preparation steps
to ensure a complete program
installation. These steps must be
performed prior to installing the Banks
AutoMind calibration.
WARNING
• Failure to follow proper
instructions can result in a
damaged or disabled ECM (Engine
Control Module).
• Do not perform any operations on
Banks AutoMind Programmer while
vehicle is running. The vehicle must
be parked and engine OFF.
Precautions for Calibration
Process
The vehicles Batteries must be
fully charged and in good condition
before using the Banks AutoMind
Programmer.
NOTE: Always turn off all auxiliary vehicle
systems or functions that might come
active while the key in the vehicle is in
the “ON” position. Locate the fuse box
and remove the fuses for the fuel pump
cooling fans and all auxiliary systems or
functions. Auxiliary systems/functions
draw power from the battery and can
cause the download/upload process to
take longer or freeze the process if the
battery charge is to low.
Familiarize yourself with Banks
AutoMind Programmer keypad
controls. The keypad will allow the
user to navigate between screens and
to select functions. (See Figure 1).
Section 3
PREPARING VEHICLE & CONNECTING BANKS AUTOMIND
PROGRAMMER
Figure 1