Connecting to obd ii 5 – Banks Power Jeep Trucks: (Gas ’91 - 06 Wrangler 4.0L) Programmer- AutoMind Programmer User Manual

Page 8

Advertising
background image

8

97270 v.4.0

1.

Do not activate any electrical

accessories while installing the Banks

AutoMind calibration. Ensure that

there are no electronic devices wired

or plugged into the vehicle that can

cause a substantial voltage drop,

which might be activated during the

installation process. Please contact

a Banks dealer if uncertain about

devices that are on your vehicle.

2.

Certain cellular phones or

radio equipment might also cause

interference, please remove or turn

such devices off.

3.

Unless instructed in the installation

steps, never turn the ignition key

OFF while the Banks AutoMind

programmer is plugged into the OBDII

connection port.

WARNING: Unplugging the

Banks AutoMind Programmer

while uploading or

downloading a calibration can

damage the vehicles ECM.

4.

Ensure that the factory “stock”

calibration is in the vehicle’s ECM

before installing the Banks AutoMind

calibration. If you are uncertain if your

vehicle is in stock condition tune then

have the vehicle’s ECM reflashed by

your vehicle’s make dealer.
NOTE: Dealer re-flashes are the same

as stock factory calibration.

WARNING: The Banks AutoMind

calibration should not be installed

over a non-factory/aftermarket

performance tune, and except

in rare sases should not be used

in conjunction with other tuning

devices such as chips or plug in

modules of any kind.

COMBINING DEVICES IS DONE AT

THE USER’S OWN RISK

Connecting to OBD II
5.

Locate the OBD II connection port

in your vehicle. The OBD II connection

port is located under the dash panel

and can be located on either side of

the steering wheel.

6.

Connect your Banks AutoMind

Programmer to the vehicle OBD II

connection port.
NOTE: When the OBD II connector

is plugged in, the Banks AutoMind

programmer will automatically power

on and illuminate its start up screen.

If the Banks AutoMind programmer

does not come on then check the fuse

to the cigarette lighter or OBD II in

the fuse panel. The screen will display

Banks

(See Figure 2), then display the

AutoMind Warning and Disclaimer.

-END, SECTION 3-

Figure 2

Advertising