Monster exhaust system installation – Banks Power Jeep Trucks: (Gas ’12 - 14 3.6L) Exhaust- Monster Exhaust, Single out the back 2012 3.6L Wrangler 2-door User Manual
Page 4
4
96501 v.1.0
1.
Disconnect the negative (ground)
cable from the battery (if there is more
than one battery, disconnect both
negative cables). Secure the cable so
it cannot accidentally come in contact
with the post.
2.
Raise the vehicle and support it
securely with properly weight-rated
safety stands, ramps or a commercial
hoist. Take care to balance the vehicle
to prevent it from slipping or falling.
When using ramps, be sure the wheels
are centered squarely on the topsides.
Place the transmission in park
(automatic), set the parking brake and
securely block the wheels that are on
the ground.
Caution: Do not WoRK unDER
anY VEHiCLE SuPPoRtED onLY
BY a JaCK. SEVERE inJuRY MaY
RESuLt.
3.
Loosen and remove the band clamp
from the inlet of the muffler. Remove
the front and rear muffler hanger pins
from the rubber hangers. Remove the
factory muffler from the vehicle. See
Figure 2.
NOTE: Spray lubricant may assist in
hanger pin removal. Rubber hangers
can also be removed from the vehicle
to assist in muffler removal.
WaRninG! the following step
may require the use of a torch
and/ or saw. Proper safety
equipment should be used.
Failure to use proper safety
equipment may result in severe
injury.
4.
Measure 10.5” from the rear hanger
behind the factory resonator to the
rear of the vehicle along the lower part
of the tailpipe and mark the location.
See Figure 3.
Monster Exhaust System installation
Figure 2