Banks Power Jeep Trucks: (Gas ’12 - 14 3.6L) Exhaust- Monster Exhaust, Single out the back 2012 3.6L Wrangler 2-door User Manual
Page 6
6
96501 v.1.0
6.
Place a 2.5” saddle clamp on the
inlet of the Monster Muffler. (Note
the inlet labeling of the muffler) Install
the Monster Muffler onto the front
tailpipe. Orient the Monster Muffler
such that it is parallel with the cab and
the Monster logo is visible once the
exhaust is installed. Loosely tighten
the 2.5” clamp (See Figure 4)
7.
Place a 2.5” saddle clamp on the
outlet of the Monster Muffler. Install
the rear tailpipe into the Monster
muffler. Insert the Banks hanger pin
into the vehicle’s rubber hanger.
Adjust the tailpipe so that it is straight
and flat under rear bumper. Loosely
tighten the 2.5” clamp.
8.
Install the 2.5” band clamp onto
the turndown tip inlet. Install the tip
and clamp assembly onto the tailpipe
outlet. Adjust the tip to be flat under
the body panel, such that the tip
position is aesthetically pleasing (See
Figure 4).
9.
Adjust each of the pipes to ensure
that all of the hanger pins are parallel
with the frame mounted pins and that
the rubber hangers are all positioned
slightly forward (See Figure 5). This
allows the hangers to be properly
positioned once the exhaust reaches
operating temperature.
10.
With the exhaust positioned
properly, begin to evenly tighten the
clamps starting with the ones closest
to the front of the vehicle and working
your way back. Torque the exhaust
clamps evenly to 35 ft-lbs. Make sure
that each slip is fully inserted (+/-
1
⁄
4
”).
RUBBER HANGER
FRONT TAILPIPE
REAR
TAILPIPE
2.5"
BAND
CLAMP
2.5"
SADDLE
CLAMP
BANKS
TURNDOWN
TIP
MONSTER
MUFFLER
(NOTE: INLET
DIRECTION)
Figure 4