Banks Power Jeep Trucks: (Gas ’12 - 14 3.6L) Exhaust- Monster Exhaust, Single out the back 2012 3.6L Wrangler 2-door User Manual
Page 5
96501 v.1.0
5
NOTE: Begin cutting just where the
tubing begins to bend at the top. Try
to leave as much straight tailpipe to
receive Banks Front tailpipe.
Using a reciprocating saw, cut the
factory tailpipe. Take time when
measuring and cutting the factory
tailpipe to ensure the proper location
and a straight cut. Improper cut will
result in poor fitment of the Banks
Monster Exhaust system.
NOTE: Gale Banks Engineering has
tested and designed this Monster
Exhaust System to work with the
factory resonator. Keeping the
factory straight-through resonator
design on the vehicle will not
reduce performance and it will help
reduce resonance in-cab due to the
aggressive camshaft profiles and
variable valve timing of the engine
design.
5.
Place a 2.5” saddle clamp on the
inlet of Banks Front tailpipe. From the
vehicle rear, route the Front tailpipe
over the rear end. Install the Front
tailpipe onto the factory tailpipe
outlet. Insert Banks hanger pin into
the vehicle’s rubber hanger. Loosely
tighten the 2.5” clamp.
NOTE: All clamps should be positioned
at the beginning of the slots (on the
1
⁄
2
circle punch).
NOTE: Once the pipe / muffler has
been completely engaged in the slip
joint, mark the pipe with a scribe or
tape for reference when tightening the
clamps later in the installation. Mark
each slip joint in this fashion.
Figure 3