Banks Power Ford Motorhomes: (Gas ’97 - 05 6.8L V-10, Class-A (20-valve)) Power Systems- PowerPack, Stinger & Git-Kit Systems, (Class-A) '97-05 User Manual
Page 10
26.
Two tailpipe options are available
to provide either a right side or
left side tailpipe exit. Refer to the
installation steps that are appropriate
to your installation.
Left exit tailpipe: position a 3
1
⁄
2
” clamp
over the muffler outlet, and place the
Banks Monster tailpipe up over the
driveshaft and slide it into the outlet
of the muffler. Place the pin hanger
on the pipe into the rubber hanger
attached to the left side of the frame.
Support the pipe level with the vehicle
and tighten the clamp.
Right exit tailpipe: place a 3
1
⁄
2
” clamp
over the muffler outlet, and insert the
Banks Monster tailpipe into the end
of the muffler. Attach the universal
hanger to the tailpipe with a 3
1
⁄
2
”
clamp, then find a suitable hole in the
frame rail directly over the tailpipe.
With the tailpipe supported level
with the vehicle, bolt the hanger into
the hole with the
5
⁄
16
” x 1
1
⁄
4
” bolt,
washers and nuts also provided.
27.
Mount the floor heat shield and
polished tip onto the pipe using the
3
1
⁄
2
” clamps provided, as shown in
figure 5.
28.
Lower the vehicle and reconnect
the battery cables. Start the engine
and listen for any exhaust leaks.
Tighten bolts or clamps to correct any
leaks or make adjustment as required.
It is recommended that tack welds
be placed on all slip connections to
prevent slippage.
Note: The vehicle exhaust may smoke upon
initial start-up. This is normal, as grease
used in the tube-bending process burns out
of the pipes.
For Git-Kit installation, procedure is
complete.
-end, section 2-
10
96378 v.6.0