Ram air intake – Banks Power Ford Motorhomes: (Gas ’97 - 05 6.8L V-10, Class-A (20-valve)) Power Systems- PowerPack, Stinger & Git-Kit Systems, (Class-A) '97-05 User Manual
Page 11
29.
Inside the vehicle with the engine
cover removed, find the rubber
bellows at the inlet of the throttle
body. Loosen the clamp attaching the
plastic air inlet tube to the bellows,
loosen it and pull the plastic air inlet
tube out of the rubber bellows. At the
front of the vehicle, loosen the clamp
that holds the forward end of the
air inlet tube to the air filter housing
elbow. Remove the tube from the air
filter housing, elbow and pull the tube
forward, out of the vehicle.
30.
To install the Banks Ram-Air air
inlet tube into the vehicle, place the
forward end into the air filter housing
elbow, and the rear end into the
rubber bellows on the throttle body.
Tighten both clamps.
Section 3
RAM AIR INTAKe
MAKe FOUR
1
⁄
2
-
INCh DeeP SAW
CUTS AROUND
eND OF SUPeR-
SCOOP OUTLeT
NO. 64
hOSe
CLAMP
1
⁄
2
”
Figure 6
96378 v.6.0
11