Banks Power Ford Motorhomes: (Gas ’97 - 05 6.8L V-10, Class-A (20-valve)) Power Systems- PowerPack, Stinger & Git-Kit Systems, (Class-A) '97-05 User Manual
Page 9
24.
Disconnect and remove the
factory tailpipe and muffler from the
rear of the factory intermediate pipe.
Start from the rear and work forward,
prying the pins from the rubber
hangers, removing the tailpipe, then
the muffler. If the slip joints will not
come apart, use a torch to heat the
connections until they separate, or cut
the pipes apart with a saw or torch,
being careful to not cut the outlet
portion of the intermediate pipe. Save
all hardware and hangers as some
items will be reused in the PowerPack
installation.
NOTe: Wheelbases over
208” may need to use extension kit P.N.
49097.
25.
Slide a 3” exhaust clamp over the
forward end of the Banks Dynaflow
®
muffler assembly and install the
assembly onto the end of the catalytic
converter outlet pipe. Position the
pin hangers on the muffler assembly
into the rubber hangers on the frame,
and adjust the rotation of the muffler
as necessary to position the hanger
pins level in the vehicle. Make sure
that the hangers are hanging forward.
This will allow the hangers to swing
as the exhaust system expands while
the engine is running. With the muffler
level and square to the frame of the
vehicle, tighten the clamp on the
muffler assembly inlet.
Section 2
MONSTeR exhAUST
Figure 5
96378 v.6.0
9