Banks Power Ford Motorhomes: (Gas ’97 - 05 6.8L V-10, Class-A (20-valve)) Power Systems- PowerPack, Stinger & Git-Kit Systems, (Class-A) '97-05 User Manual
Page 7
12.
On some motorhomes there is a
vertical hose fitting on top of the air
conditioner compressor. (Skip this step
if your motorhome does not have the
vertical fitting.) Before installing the
right side TorqueTube, bend the hose
fitting
1
⁄
4
-
1
⁄
2
inch towards the frame
rail using a pry bar. Be careful not to
crease or puncture the fitting. This will
give clearance for the TorqueTube.
Wrap the hose with the supplied heat
shield blanket. Secure the blanket to
the hose with the supplied wire ties.
13.
Inspect the exhaust mounting
surfaces of the cylinder heads
and clean away any deposits to
assure proper sealing of the Banks
TorqueTubes. Be careful when doing
this as the cylinder heads are made
from aluminum, and can be easily
damaged. We recommend the use of a
Scotchbrite
®
pad.
14.
Place a small amount of anti-seize
on the threads of each of the supplied
manifold bolts. Use the new gaskets
provided when installing TorqueTubes.
Lift the Banks TorqueTube manifolds
into place and install one or two bolts
to hold them in position. Install the
remaining bolts into the heads and
tighten. see
figure 1.
15.
On EGR models, attach the EGR
tube to the adapter fitting in the Banks
TorqueTube manifold. If necessary,
loosen the fitting at the top of the EGR
Figure 3
Figure 2
96378 v.6.0
7