Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Powertrain- Banks Billet Torque Converter '03-07 User Manual
Page 12
12
96799 v.2.0
15.
For models with dual generators,
remove the outer accessory drive belt
from the crankshaft pulley by rotating
the tensioner.
16.
To access the converter nuts,
remove the cylinder block opening
cover. See Figure 10.
17.
Remove the torque converter
nuts by rotating the crankshaft pulley.
NoTe: A suitable strap wrench can be
used to rotate the crankshaft pulley
with the drive belt removed.
18.
A drain pan should be positioned
under the working area. Disconnect
the transmission fluid cooler tubes
located on the right side of the
transmission and allow them to drain
into the drain pan. See Figure 11.
21.
Remove the nine (9) transmission
mounting bolts.
22.
Carefully slide the transmission
and torque converter assembly
rearward.
WARNING: Torque Converter can
slide off the turbine shaft. Secure
the converter when removing
the transmission and torque
converter assembly from the
engine.
NoTe: The fluid filler tube will detach
from the transmission when lowering
the transmission.
23.
Lower the transmission and
remove it from under the vehicle.
24.
Once the transmission and torque
converter assembly are removed,
place a suitable drain pan under
the converter housing end of the
transmission.
CAUTION: Verify that the
transmission is secured to the
lifting device. When torque
converter is removed, the
transmission’s center of gravity
will shift and transmission may
become unstable.
Figure 10