Installation procedure, Banks billet torque converter – Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Powertrain- Banks Billet Torque Converter '03-07 User Manual
Page 6
6
96799 v.2.0
1.
Disconnect the negative (ground)
cable from the battery (if there is more
than one battery, disconnect both
negative cables). Secure the cable so
it cannot accidentally come in contact
with the post.
2.
Raise the vehicle high enough to
remove the transmission and support
it securely with properly weight-rated
safety stands, ramps or a commercial
hoist. Take care to balance the vehicle
to prevent it from slipping or falling.
When using ramps, be sure the wheels
are centered squarely on the topsides.
Set the parking brake and securely
block the wheels that are on the
ground.
CAUTION: DO NOT WORK UNDER
ANY VEHICLE SUPPORTED ONLY
BY A JACK. SEVERE INJURY MAY
RESULT.
3.
Remove the rear drive shaft.
A) Mark the driveshaft and the
transmission or transfer case
output shaft/ circular flange and
mark the driveshaft at the rear
axle pinion flange to help with
re-alignment during reassembly.
See Figure 1 & 2.
B) For models with circular flange,
loosen and remove the bolts
connecting the driveshaft to the
transmission or transfer case
circular flange.
C) For models with three piece
driveshaft, loosen and remove
the bolts and u-joint retainers to
disconnect the drive shaft from the
coupling shaft.
D) For models with two and three
piece driveshaft, remove the center
bearing support bolts. See
Figure 3.
Installation Procedure
Banks Billet Torque Converter
Figure 1 For Vehicles Without Circular Flange