Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Power Systems- PowerPack & Stinger w EconoMind ('03-07) Compatible w_ Optional PowerPDA - Manual (Page 24)

24
96811 v.10.0
Section 4
BANkS OTTOMIND6 DIESEL TuNER INSTALLATION
Banks OttoMind6 Diesel Tuner
Installation
1.
Make sure the previously removed
driver side battery is not installed. If
the driver side battery is installed or
if any battery is still connected then
refer to Section 1 Steps 1 thru 5 for
battery removal instructions.
2.
Place the OttoMind6 Diesel Tuner
in close proximity as shown in Figure
28 for 2003-04 and Figure 29 for
2005-07. The ‘In-cab cable’ with the
three small connectors will be routed
into the cabin through the grommet
on the firewall.
The MAP sensor harness with the
two connectors will be routed along
the firewall to its prospective location
listed in the following steps.
Note: (The OttoMind6 Diesel Tuner will
be affixed to its permanent location in
step 19.)
3.
Locate the Powertrain control
Module (PcM) on the driver side of
the vehicle engine compartment (see
Figure 30).
4.
Disconnect the middle connector
from the PcM by opening the over
center retaining clamp as shown in
Figure 30. Route the disconnected
PcM connector to the OttoMind6
Diesel Tuner as directed below:
2003-04 model year vehicles: Route
the previously disconnected middle
connector under the power steering
fluid reservoir towards the OttoMind6
Diesel Tuner.
2005-07 model year vehicles: Route
the previously disconnected middle
connector in the most direct path
towards the OttoMind6 Diesel Tuner.
5.
All Years: Plug the PcM connector
into the connector on the OttoMind6
Diesel Tuner labeled, ”VEHIcLE
HARNESS”.
6.
Locate the supplied ‘crossover
cable’ wiring harness in your
OttoMind6 tuner kit.
7.
Plug the supplied ‘crossover cable’
wiring harness into the OttoMind6
Diesel Tuner connector labeled,
“BANKS HARNESS.”
For 2005-07 Model years, slide Six-
Gun shield onto crossover cable.
Note: Be sure that the seam on the
top of the shield is facing away from
the cabin (see figure 33)
.
For all models, route the other
end of the ‘crossover cable’ to the
vehicle’s PcM middle connector
labeled “c”. Route the ‘crossover
cable’ as directed below:
2003-04 model year vehicles: Route
the ‘crossover cable’ under the
power steering fluid reservoir.
2005-07 model year vehicles: Route
the ‘crossover cable’ to the PcM in
the most direct path possible.
8.
All Years: Plug the ‘crossover
cable’ into the vehicle’s PcM middle
connector labeled “c”.
9.
Unplug the Manifold Absolute
Pressure (MAP) sensor connector
shown in Figure 31. The MAP
connector can be unplugged by sliding
the red safety slide down, pressing
the locking button, then pulling on the
connector.
Figure 27: Six-Gun and supplied wiring harnesses