Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Power Systems- PowerPack & Stinger w EconoMind ('03-07) Compatible w_ Optional PowerPDA - Manual (Page 29)

96811 v.10.0
29
Not needed if installing the Power
Level Selector Switch. Please proceed
to Section 6.
Note: This system has been
designed for use with the Palm
Tungsten E2 PDA.
WARNING: The PDA may be
susceptible to damage as a
result of extended exposure
to sunlight, heat or extreme
cold. It is highly recommended
that the PDA be removed from
its mounting location if the
vehicle will be subjected to high
concentrations of sunlight, heat
or cold for an extended period
of time. Gale Banks Engineering
is not responsible for damage to
PDAs resulting from exposure
conditions.
Mounting the Docking Station
Locate the Docking Station in your kit.
The mounting location of the Docking
Station is vehicle specific. It is not a
universal fit. Make sure to do a dry
pre-fit before permanently mounting.
For mounting locations, refer to the
following figures:
Figure 39 – Ford (’03-’04)
Figure 40 – Ford (’05-07)
Proceed to Section 6 after you
have Mounted the docking station
and connected the PowerPDA
Note: In cold climates, best results
will be obtained if the vehicle’s heater
is run to bring the inside temperature
up to “room temperature” (at least
68°F).
1.
clean mounting area with
isopropyl alcohol or similar residue
free cleaning agent to prepare the
surface for the adhesive tape.
2.
The Docking Station has adhesive
tape applied to it at the factory. Prior
to removing the protective liner from
the tape, test fit the unit on the dash
as indicated in the appropriate photo.
Refer to the figure list above for
vehicle-specific mounting locations.
The Docking Station will fit the dash
contours only where shown in the
photos.
Section 5
MOuNTING THE DOCkING STATION AND CONNECTING THE BANkS POWERPDA
VEHICLE COMMAND CENTER
Figure 39 Ford (’03-’04)
Figure 40 Ford (’05-07)