Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner, (325 HP Dodge 5.9L Cummins (24-valve) Trucks) '06-07 Compatible with Optional PowerPDA User Manual
Page 19
96810 v.7.0
19
Not needed if optional Banks
PowerPDA is installed.
Caution: Do not use force
when working on plastic parts.
Permanent damage to the part
might result.
Two holes must be drilled into the
instrument cluster bezel that will
require the removal of the instrument
cluster bezel, cup holder / storage
tray, vertical panel and instrument
panel center bezel. Alternatively,
two holes can be drilled with the
instrument cluster still in place if a
right angle drill and
1
⁄
8
Uni-drill bit is
used.
• Step 1 thru 9 to install the Six-Gun
switch on the instrument cluster
bezel without a right angle drill.
• Step 10 thru 14 to install the
Six-Gun switch on the instrument
cluster bezel using a right angle
drill.
• Step 15 thru 18 to install the Six-
Gun switch in the accessory switch
cutout.
Note: Some vehicles are equipped
with an electric pedal adjustment
switch. If your vehicle is equipped
with this switch then do not install the
Banks Six-Gun switch in this location.
• Step 19 to 21 to install switch in
location of your choice.
Drilling Instrument Cluster Bezel
without a right angle dill
Step 1 thru 9.
1.
Remove the screws and unclip the
knee dash panel located under the
steering wheel and set aside.
2.
Remove the cup holder / storage
tray. The screws are located under
the rubber inserts. Remove the rubber
inserts then remove the screws and
set the cup holder / storage tray aside.
See Figure 18.
Section 3
INSTALLATION OF THE SIx-GUN SELECTOR SWITCH
Figure 17