Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner, (325 HP Dodge 5.9L Cummins (24-valve) Trucks) '06-07 Compatible with Optional PowerPDA User Manual
Page 22
22
96810 v.7.0
Note: the piece of sheet metal is
intended to be used as a safety barrier
in the prevention of over drilling.
15.
Skip to Step 23 to continue.
Installing Six-Gun Switch in the
accessory cutout panel.
Step 16 thru 19
16.
Remove the screws and unclip
the knee dash panel located under the
steering wheel and set aside.
17.
Remove the accessory cutout by
pressing the retaining tabs located on
the backside of the part and set aside.
18.
cut out the supplied template
(see Figure 25b on page 35) and
align the template onto the front of
the accessory cutout by centering it to
the part. Use masking tape to securely
hold down the template. 2
Note: Do not tape over the markings
on the template.
19.
Skip to Step 24 to continue.
Installing Six-Gun Switch custom
location
Step 20 thru 22
CAUTION: Make sure that that
area of your choice can be drilled
without damaging any components
located behind the surface.
Remove panel as needed to ensure
no drilling interference.
20.
Locate an area of your choice
where you would like to install the Six-
Gun switch.
21.
cut out the supplied template
(see Figure 25b) and align the
template onto the front of the area of
your choice. Note: use the template to
align hole to be drilled. Use masking
tape to securely hold down the
template. Note: Do not tape over the
markings on the template.
22.
Skip to Step 24 to continue.
23.
cut out the supplied template
(see Figure 25a) and align the
template onto the front of the cluster
bezel by placing its left edge against
the cluster rib, and its bottom edge
against the cluster bottom edge. Use
masking tape to securely hold down
the template. Note: Do not tape over
the markings on the template.
24.
Using a
3
⁄
8
” Uni-drill, center the
bit onto the
3
⁄
8
” drill location on the
template and slowly drill through the
panel. Using a
1
⁄
8
” drill bit, center and
drill through the
1
⁄
8
” location on the
template. Remove and discard the
template and any plastic shavings.
Note: It is important that the hole
is drilled at the recommended
location. the switch may not clear the
instrument panel structure if the hole
is shifted to another location.
25.
Align the Banks Six-Gun label
onto the previously drilled hole. Make
sure the entire mounting surface is
clean and free of dirt and oil before
mounting the label. Clean and dry as
required using a cloth dampened with
rubbing alcohol or similar cleaning
solution.
CAUTION: Do not spray fluid
directly onto any electrical
equipment, or equipment damage
may result.
Mount the Six-Gun Diesel Tuner
switch label onto the drilled panel
by peeling the protective backing off
the adhesive tape on the back of the
switch label. Hold the label against the
panel for approximately 20 seconds
while applying pressure to allow the
adhesive to properly adhere to the
surface.
26.
Remove the nut and internal
tooth washer from the Six-Gun switch.
Rotate the shaft counter clockwise
until the shaft stops. Verify that the