Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner, (235, 250, 305 and 325 HP Dodge 5.9L Cummins Trucks (24-valve)) '03-05 Compatible with Optional Banks iQ User Manual
Page 19
96821 v.4.0
19
4.
Find a suitable place on the
windshield for ease of access and
viewing of Banks iQ. Use location
shown in Figure 15 as a reference
for mounting Banks iQ in your
vehicle. Loosen the knob and move
the swivel suction plate to achieve
desired viewing angle of the Banks
iQ screen. Do a test fit and note the
angle necessary to achieve the correct
viewing angle.
5.
Make sure the suction cup and the
mounting area on the windshield are
clean and dry. With the suction lever
in the up position, ensure the suction
cup is flat against the windshield, and
then push the suction lever down to
secure in place.
6.
Next, remove and set the side dash
access panel aside.
7.
Locate the RJ12 cable (similar
to telephone connector) previously
secured behind the knee panel.
Remove the knee panel to gain access
to the RJ12 cable. See Figure 16.
8.
Locate Banks iQ Bridge Module and
connect the RJ12 connector into the
bridge module. See Figure 17.
9.
Route the Banks iQ USB interface
cable from the Banks iQ Bridge Module
under the dash and out through the
side access panel opening. The cable
can be slid under the door frame’s seal
and run up to the top of the dash. Pull
enough cable to reach the Banks iQ
and connect it to the USB receptacle
on the left side of Banks iQ. See
Figure 15. Snap the side access panel
back in place making sure not to pinch
the wire.
Figure 15 Mounting location for Banks iQ