Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner, (235, 250, 305 and 325 HP Dodge 5.9L Cummins Trucks (24-valve)) '03-05 Compatible with Optional Banks iQ User Manual
Page 21
96821 v.4.0
21
WARNING: THE CHARGING CABLE
CONNECTED TO THE BANKS iQ IS
DESIGNED TO SUPPLY A CONSTANT
LOW-VOLTAGE POWER SOURCE
(+5VDC) TO THE BANKS iQ AND IS
“LIVE” AS LONG AS THE SYSTEM’S
OBD II INTERFACE CABLE OR BANKS
WIRING HARNESS IS COMPLETELY
INSTALLED AND THE USB CABLE
CONNECTOR IS PLUGGED INTO
BANKS iQ. ALTHOUGH THIS
CHARGING CABLE IS SHORT AND
ITS CIRCUITRY IS FUSE-PROTECTED,
THE USER IS ExPECTED TO TAKE
APPROPRIATE MEASURES TO
PREVENT SMALL CHILDREN AND/
OR PETS FROM CONTACT WITH ANY
PART OF THIS SYSTEM.
10.
Secure Banks iQ Bridge Module
under the dash to any dash frame
support using the supplied cable ties.
Use the cable tie support loops on the
side of the Bridge Module to securely
fasten it under the dash.
11.
Route all wiring away from any
pedals or other moving components.
Using the cable ties supplied, secure the
wiring under the dash.
12.
Reinstall the lower knee panel
back in place with the factory
hardware. Tuck any excess cable
behind it for a clean appearance.
-END, SECTION 2-
Not needed if optional Banks iQ is
installed.
CAUTION: Do not use force
when working on plastic parts.
Permanent damage to the part
might result.
1.
The Six-Gun switch will be installed
on the drivers side of the instrument
panel (IP) next to the steering column.
See Figure 18.
2.
Remove the headlamp switch bezel
on the drivers side by gently pulling on
it. Disconnect the electrical connector
once the bezel is removed.
3.
To remove the center bezel, open
the ashtray and cup holder and
remove the retaining screw. Gently
pull on the center bezel to disengage
all the clips that attach the bezel
to the dash. Disconnect the four
(4) electrical connections after the
bezel is removed. Keep the screw for
reinstallation.
4.
Remove the cluster bezel by first
removing the two (2) screws at the
top. Gently pull on it and disengage
all the clips that attach the bezel
to the dash. Retain the screws for
reinstallation.
5.
cut out the supplied template (see
Figure 26 on Page 35) and align the
template onto the front of the cluster
bezel by placing its left edge against
the cluster rib, and its bottom edge
against the cluster bottom edge. Use
masking tape to securely hold down
the template.
NOTE: Do not tape over the markings
on the template.
6.
Using a
3
/
8
” Uni-drill, center the
bit onto the
3
/
8
” drill location on the
template and slowly drill through the
IP. Using a
1
/
8
” drill bit, center and
drill through the
1
/
8
” location on the
template. Remove and discard the
template and any plastic shavings.
Section 3
INSTALLATION OF THE SIx-GUN SELECTOR SWITCH