Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner, (235, 250, 305 and 325 HP Dodge 5.9L Cummins Trucks (24-valve)) '03-05 Compatible with Optional Banks iQ User Manual

Page 32

Advertising
background image

32

96821 v.4.0

Section 8

CLEARING LEARNED INFORMATION

NOTE: If clearing the Six-Gun’s

learned parameters then all Banks

iQ tunable settings will be reset to

factory defaults. (Refer to the Banks iQ

Owners Manual for more detail.)
This procedure should only be

performed if:
- A ”4,2” code for transmission slip

detection is repeatedly set or will

not clear and the transmission is

not actually slipping; or

- The Six-Gun Diesel Tuner is moved

to a new vehicle; or

- The vehicle’s speedometer has been

factory recalibrated for different

gearing or tire size; or

- Instructed to do so by Banks

Technical Staff. Your Six-Gun Diesel

Tuner also has the capability to

clear the information related to the

learned transmission type and gear

ratios. The diagnostic code “4, 3”

will reappear after the procedures

are carried out correctly. Follow

the steps below to unlearn the

transmission on your Six-Gun

Diesel Tuner.

CAUTION: The following procedures

can only be carried out with the

engine not running.

1.

Turn the vehicle key to the ON

position but DO NOT start the engine.

2.

Fully depress the accelerator pedal

and then release it completely. Repeat

for 5 times. The GREEN LED will flash

when this is completed successfully.

3.

Turn the key OFF. Wait 10 seconds,

or until the GREEN LED goes off and

stays off. Turn the key to the ON

position but DO NOT start the engine.

4.

Fully depress the accelerator pedal

and then release it completely. Repeat

for 5 times. The “4,3” diagnostic

code will flash when this is completed

successfully.
NOTE: When the transmission type

and gear ratios are cleared (with code

“4,3” displayed), the engine power

returns and remains in stock level until

the Six-Gun Diesel Tuner re-learns the

transmission and the “4,3” code is

eliminated. Follow the procedures in

”Transmission Learning” (Section 6) to

eliminate the “4,3”.

-END, SECTION 8-

Advertising