Grain Systems PNEG-012 - Manual (Page 15)

4. Installation
PNEG-012 Vane Axial Heater 15
Bin Configuration
Figure 4E
IMPORTANT: When mounting two (2) heaters on a bin it is imperative that they be situated as shown in
Figure 4E . Plenum thermostat must be to the right of master heater and master heater must
be to the right of slave heater.
Transition High-Limit Installation
1. Mark location on transition one foot up from the bottom (entrance collar) and centered in
the transition.
2. Drill or knock out 7/8" diameter hole on marked location.
3. Install transition high-limit using supplied self-drilling screws.
Figure 4F The transition connecting the Vane Axial Heater to the bin with the plenum sensor in place.