Grain Systems PNEG-1181 - Manual (Page 12)

12 PNEG-1181 Portable Dryer Troubleshooting
3. Operation Tips
Network Dryer Operation Tips (Continued)
7. To return all options and settings to the factory defaults, press and hold the RESET button. Turn
the control power ON and release the RESET button. NOTE: ALL settings will be erased and all
options will return to the factory defaults.
8. To disable the air pressure switches, press and hold both the GRAIN and PLENUM buttons. Turn
ON the control power and release the buttons.
9. To erase all shut downs in the computer history, press and hold both the DRY and COOL buttons
and turn ON the control power. Release the buttons.
10. To view the shut down history of the dryer, press the UP and DOWN arrow buttons at the same
time, prior to pressing the START switch on the dryer. 256 dryer shut downs are stored in memory.
Performing this keystroke sequence while changing a timer or a delay setting, will change the
setting to 0.01.
11. Press the SCREENS button while the dryer is running to access the following data:
A. Out of Grain - View “Out of Grain” Timer
Set “Out of Grain” Timer
Check “Last Load” Time
B. View Grain Temps
C. User Hour Meter (Hour meter can be reset here also).
D. Meter Roll Speed Average. (Monitors the percentage of time the meter rolls spend on both high
and low speed.)
12. Press the SETUP button, before pressing start on the dryer in order to change the following settings:
A. Enter the BPH factor (software version 1.18)
B. Reset batch counter
C. Clear total bushels
D. Change user message
13. Press DELAYS button before pressing start on the dryer in order to access the following Delays:
A. Load Delay
B. Out of Grain
C. Fan Delay
D. Unload Clean Out Delay