Grain Systems PNEG-1181 - Manual (Page 16)

16 PNEG-1181 Portable Dryer Troubleshooting
6. Programming
Programming Instructions Using Palm Pilot
There are three (3) boards to program on the Network Dryer: Display Board (lower control box),
Input/Output Board (upper control box), and Heater Interface Board (by Fan/Can housing).
1. Turn the control power on the dryer to the OFF position.
2. Locate the programming jack on each individual board:
• Display Board (lower control panel) - (DB-9) located at bottom of board.
• Input/Output Board (upper panel) - (DB-9) located at bottom of board.
• Heater Interface Board (by fan/can housing) - (J2 connector) located on back of board.
NOTE: Refer to See Figure 6A on Page 17 .
3. If programming the Input/Output Board or Display Board, connect the DB-9 connector from the
Palm Pilot to the board.
4. If programming the Heater Interface Board, connect the J2 connector on the series 2000 cable to
the J2 connector on the back of the board.
5. Unplug the network connection (yellow and blue wires) to the board being programmed.
6. On the Palm Pilot, select the program for that particular board and select it by “tapping” on it.
7. Turn the dryer control power back ON.
8. The programming process begins by erasing the present program and starting the new program.
9. The screen will display a confirmation screen when the transfer of the software is complete.
10. Turn the dryer control power OFF and remove the connector from the board. Plug the network wires
back into the board being programmed.
11. Turn ON the dryer and the opening screens on the dryer will indicate the latest version of software.
There are two Palm Pilot kits available from GSI for order:
Ref # Part # Description
D03-0692 (Palm Flash Program Kit Deluxe)
1 D01-1771 Series 2000 Programming Cable
2 D03-0688 Palm Pilot IIIC (color)
3 D03-0694 Palm Pilot Hot Sync Cable
4 D03-0695 Palm Flash 9 Pin M-M Adapter
5 D03-0709 Disk, CD-ROM Palm Flash Software
D03-0693 (Palm Flash Program Kit Economy)
6 D01-1771 Series 2000 Programming Cable
7 D03-0689 Palm Pilot M100 (black & white)
8 D03-0695 Palm Flash 9 Pin M-M Adapter
9 D03-0709 Disk, CD-ROM Palm Flash Software