Installing a rear i/o module, Installing a rear i/o module (p. 2-5), Installation and setup – Cobalt Digital COMPASS 9083 HD_SD Frame Sync User Manual
Page 35
9083-OM (V4.5)
9083 PRODUCT MANUAL
2-5
Installation and Setup
Installing a Rear I/O Module
Installing a Rear I/O Module
Note:
This procedure is applicable only if a Rear I/O Module is not currently
installed in the slot where the 9083 is to be installed.
If installing the 9083 in a slot already equipped with a suitable I/O module,
omit this procedure.
The full assortment of 9083 Rear I/O Modules is shown and described in
9083 Rear I/O Modules (p. 2-6). Install a Rear I/O Module as follows:
1.
On the frame, determine the slot in which the 9083 is to be installed.
2.
In the mounting area corresponding to the slot location, install
Rear I/O Module as shown in Figure 2-2.
Figure 2-2 Rear I/O Module Installation
DSCN3483A.JPG
Align and engage mounting tab on Rear
I/O Module with the module seating slot
on rear of frame chassis.
Hold top of Rear I/O Module flush against
frame chassis and start the captive screw.
Lightly tighten captive screw.
DSCN3487A.JPG
Note: Rear I/O Modules RM-9083-C, -D, -E, and -H occupy two
rear module slot mounting locations and use two captive
screws.
Rear I/O Module RM-9083-G occupies three rear module
slot mounting locations and uses three captive screws.
1
2