Cobalt Digital FUSION 3G 9931-EMDE 3G_HD_SD-SDI Embedder_De-Embedder - Manual (Page 37)

9931-EMDE-OM (V1.15) 9931-EMDE PRODUCT MANUAL 2-1
Chapter 2
Chapter 2
Installation and Setup
Overview
This chapter contains the following information:
• Setting I/O Switches for Analog Audio (1-8) Ports (p. 2-1)
• Installing the 9931-EMDE Into a Frame Slot (p. 2-2)
• Installing a Rear Module (p. 2-4)
• Connecting To Phoenix Terminal Connectors (p. 2-15)
• Setting Up 9931-EMDE Network Remote Control (p. 2-15)
Note: The 9931-EMDE is suitable for installation only in a 20-slot frame (Cobalt ® PN
HPF-9000, OG3-FR, or 8321-CN or equivalent).
Setting I/O Switches for Analog Audio (1-8) Ports
Notes: • This procedure is applicable only for 9931-EMDE equipped with analog
audio options (for example, option +ANAIO). Refer to catalog or Fusion3G
®
manual supplement Analog Audio/Video Options OPT-F3GAN-MS for more
information.
• All switches are set as inputs as factory default.
Analog audio options allow the 9931-EMDE to be used with analog audio
inputs and/or outputs. The option provides for eight analog audio channel IN
or OUT, with each channel configurable as an input or output using DIP
switches S1 thru S8). The switches are located on the option piggyback card.
Note switch S1 thru S8 locations for AN-AUD I/O 1 thru AN-AUD I/O 8 shown in
Figure 2-1. For port to be used as an output, set switch to down position as
shown in Figure 2-1.