OMAX DualBRIDGE System - Manual

ACCESSORIES
DUALBRIDGE
Made in the USA WWW.OMAX.COM
FEATURES
• Each bridge has the same precision as the standard single
bridge OMAX JetMachining ® Center
• Automatic bridge collision detection
• Each bridge can use any of the precision OMAX cutting head
options for maximum versatility
• You can have different accessories on each bridge, e.g.,
a Tilt-A-Jet ® on one bridge and an A-Jet ® on the other bridge
• Up to four cutting heads on one machine
OMAX DualBRIDGE
Significantly increase productivity with the addition of a second bridge: simultaneously cut separate jobs on a single bed with a
single operator. Available on the 80X Series, 120X Series and 160X Series, the OMAX DualBRIDGE option is ideal for high-
output, high-capacity jobs, or shops with limited facility space. Retrofittable to existing 80X Series, 120X Series, and 160X
Series, two sets of the Intelli-MAX
® Software Suite on two computers control each bridge autonomously, allowing for two discrete,
independent cutting jobs to take place simultaneously.
BENEFITS
• Eliminate down times & setup times: With a DualBRIDGE System
you don’t need to stop cutting to load or unload material
• Redundancy increases productivity: one bridge can continue cutting while the
other undergoes annual inspection
• Can use both bridges to cut one large part at the same time, greatly reducing
cutting times
• Small footprint: all the features of a second waterjet machine for
the space of a pump
• Acquire the fastest cutting configuration with multiple cutting
heads and pumps on one machine