Yamaha DTXPRESS III - Manual (Page 21)

21
KIT ´´´´´´´´´´
1 Acoustic Kit
7. Change the Click Voice
When the click voice resembles voices that are found in the
song it might be hard to hear. In this case it is a good idea to
change the click voice.
Press the [UTIL] button four times (not too quickly) until the
display shown below appears.
Use the [VALUE–]/[VALUE+] buttons to select the sound set
that you want to use for the click sound.
Press the [SOUND] button to return to the original display
(song select display).
When you select “User Voice” as the click sound, you
can select the three individual sounds used for the click
sound (voice), and set volume, tuning, etc. (m Utility
Mode [4. CLK (Click) Group] P.34)
8. Change the Drum Kit
When you want to use a different drum kit with a particular
song, press the [DRUMKIT] button to enter the Drum Kit se-
lect display, then select the drum kit you want to use.
Play Along with a Song
Drum Kit Name Drum Kit Number
Produces sound
UT TG MASTER
MuteK=mS=®C=®M=®
Mute (Does not produce sound)
UT CLK VOICESET
=Metronom
Sound set name used for click sound
9. Change the Song but Not the Drum Kit
Normally, when the song is switched the drum kit will be au-
tomatically switched to the kit that is set in the song. However,
if the Rhythm Mute Function ([SHIFT]+[PAGEs]) is used,
the drum kit will not change when the song is switched.
* Also, in the Utility mode’s [3-2. Channel 10 Program Change/
Receive Channel Event] (Reference Guide : P. 32) set the
Channel 10 Program Change to not receive program
changes and then only the song will change.
10. Mute Individual Drums
You can mute individual drums like the [Bass Drum], [Snare
Drum], [Cymbal], [Other Drum Instruments].
This function is convenient when you want to practice indi-
vidual drum parts.
Press the [UTIL] button, then press the [PAGEt] button to
enter this display.
Use the [SEL<]/[SEL>] buttons to select the drum instru-
ment (K: Bass Drum, S: Snare Drum, C: Cymbal, M: others)
you want to mute, then press the [VALUE+] button to change
the speaker icon (®) to the mute icon (m).
To cancel the Mute Function, press the [VALUE–] button to
return to the speaker icon (®).