Rainbow Electronics GM862-QUAD-PY - Manual (Page 21)

GM862-QUAD / PY Software User Guide
1vv0300747 Rev. 3 - 10/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved page 21 of 96
•
send command
AT#MONI?<cr>
•
wait for response in the format:
#MONI: <netname> BSIC:<bsic> RxQual:<qual> LAC:<lac> Id:<id> ARFCN:<arfcn>
PWR:<dBm> dBmTA: <timadv>
OK
or in the case the network name is not known:
#MONI: Cc:<cc> Nc:<nc> BSIC:<bsic> RxQual:<qual> LAC:<lac> Id:<id> ARFCN:<arfcn>
PWR:<dBm> dBm TA: <timadv>
OK
where:
<netname> = name of network operator
<cc> = country code
<nc> = network operator code
<n> = progressive number of adjacent cell
<bsic> = base station identification code
<qual> = quality of reception (0-7) (same as <ber> of +CSQ command)
<lac> = localization area code
<id> = cell identifier
<arfcn> = assigned radio frequency channel
<dBm> = received signal strength in dBm (same as "decoded" rssi value)
<timadv> = timing advance
For example:
command:
AT#MONI=0<cr>
Answer:
OK
command:
AT#MONI?<cr>
Answer:
#MONI: I TIM BSIC:23 RxQual:7 LAC:AEAD Id:5265 ARFCN: 59 PWR: -80 dBm TA:0
OK
In this case the mobile is registered on the network "I TIM", the signal strength is -80dBm (MMI may
indicate 4 antenna bars as reported on the table 5). The other information received is strictly technical
and should not be given to the user.
For example2:
command:
AT#MONI=0<cr>