Rainbow Electronics GM862-QUAD-PY - Manual (Page 61)

GM862-QUAD / PY Software User Guide
1vv0300747 Rev. 3 - 10/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved page 61 of 96
0 - TA buffer of unsolicited result codes defined within this command is flushed to the TE when
<mode>=1..3 is entered (OK response shall be given before flushing the codes)
1 - TA buffer of unsolicited result codes defined within this command is cleared when <mode>=1..3
is entered.
NOTE: issuing AT+CNMI<CR> is the same as issuing the Read command.
NOTE: issuing AT+CNMI=<CR> is the same as issuing the command AT+CNMI=0<CR>.
•
wait for OK
TIP: In this command description the values that are always 0 are parameter reserved for future
use, in the current software revision the only value supported is 0.
For example:
1- Let's assume you want to eliminate all the unsolicited codes that may be sent when receiving SMS
& Status Report:
command:
AT+CNMI= 0,0,0,0,0<cr>
response:
OK
For example about a new message indication:
1- Let's assume you receive a new SMS delivery (AT+CNMI=1,1,0,0,0) and this new message is
stored on the SIM "SM" storage at the location number 7; the unsolicited code you will receive (if code
is enabled) is:
unsolicited code:
+CMTI: "SM",7
2- Let's assume you receive a new SMS Status Report delivery (AT+CNMI=1,0,0,2,0) and this new
message is stored on the SIM "SM" storage at the location number 8; the unsolicited code you will
receive is:
unsolicited code:
+CDSI: "SM",8