Rainbow Electronics GM862-QUAD-PY - Manual (Page 42)

GM862-QUAD / PY Software User Guide
1vv0300747 Rev. 3 - 10/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved page 42 of 96
RING
+CLIP: "+391234567890",145
NOTE: this does not mean that the incoming call is an international one, it simply means that the
numbering scheme used to identify the caller is the international one.
3.2.4 Restricting Calling Line Indication
The GM862-QUAD / PY is able to send the calling line indication (CLI) to the other party through the
network when an outgoing call is made. This indication can be restricted (CLIR) in various ways:
•
CLI sent always
•
CLI never sent
•
CLI temporary sent (normally not sent)
•
CLI temporary not sent (normally sent)
3.2.4.1 CLIR Service status query
•
send command AT+CLIR?<cr>
•
wait for response in the format:
+CLIR: <n>,<m>
OK
where:
<n> is the facility status on the Mobile
0 – CLIR facility according to CLIR service network status
1 – CLIR facility active (CLI not sent)
2 – CLIR facility not active (CLI sent)
<m> is the facility status on the Network
0 - CLIR service not provisioned (service unavailable)
1 - CLIR service provisioned (service available)
2 - unknown (e.g. no network present, etc.)
3 - CLI temporary mode presentation restricted
4 - CLI temporary mode presentation allowed
NOTE: The <m> parameter reports the status of the service at network level.
If the CLIR service is not provisioned, then it is not possible to use this service and changing
the first parameter <n> will not change the CLI presentation to the other party behavior of the
network.
For example:
1- Let's assume you want to check your CLIR settings:
command:
AT+CLIR? <cr>