Rainbow Electronics GM862-QUAD-PY - Manual (Page 43)

GM862-QUAD / PY Software User Guide
1vv0300747 Rev. 3 - 10/07/07
Reproduction forbidden w ithout Telit Communications S.p.A. w ritten authorization - All Rights Reserved page 43 of 96
response:
+CLIR: 2,4
In this case the CLIR service is temporary mode allowed on the network and the mobile sends the CLI
when calling. (CLI Restriction not active).
3.2.4.2 Restrict/Allow Caller line ID indication
•
Send command AT+CLIR=<n><cr>
where:
<n> is the operation mode selected:
0 – Calling Line Indication to the other party According to Network service status.
1 – Calling Line Indication Restriction Enabled (CLI not sent)
2 – Calling Line Indication Restriction Disabled (CLI sent)
•
wait for
OK
response
For example:
1- Let's assume you want to disable the CLI presentation to the other party permanently:
command:
AT+CLIR=1<cr>
response:
OK
3.2.5 Call Barring Control
The call Barring is a GSM service that allows the user to block certain types of calls:
•
Barring All Outgoing Calls
•
Barring Outgoing International Calls
•
Barring Outgoing International Calls except to Home Country
•
Barring All Incoming Calls
•
Barring Incoming Calls when Roaming outside the home country
•
All Barring services (applicable only for disabling command)
•
All Outgoing barring services (applicable only for disabling command)
•
All Incoming barring services (applicable only for disabling command)
The service can be queried, enabled and disabled.
NOTE: The call Barring service is handled by the network, hence all the relative commands
issue a network request and it may take several seconds to have the response from the
network.
Furthermore, all the Call Barring service commands must be issued when the mobile is
Registered on some Network, else an error code is returned ( no network service ).