B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 243)

Airborne Enterprise CLI Reference Manual 243
wl-tunnel-p2
Command wl-tunnel-p2
Arguments 0 | 1
Security
Level
3 (config)
Device Type Serial | UART | SPI
Default 0
Description Enables or disables the tunnel port (wl-tunnel-port-p2) assigned to the Serial 2 (UART2) interface,
for communications.
The tunnel port does not require authentication using the CLI command (auth <username>
<password>
) and will automatically establish a data tunnel with the Serial 2 (UART2) interface only if it
is in listen mode.
0 Disables the tunnel port.
1 Enables the tunnel port.
The tunnel can be enabled/disabled without needing a restart.
The Use of the –p1 suffix is optional.

Opening the tunnel port presents a potential security risk. Since no authentication is
needed to establish a data connection, leaving the port enabled may allow
unauthorized access to the host system.