American Car Craft Corvette Inner Fender Covers Polished 4Pc 2006-2013 Z06 only - Manual (Page 2)

2. Slide the backside of your new passenger cover under the gasket ridge and
down over the fuse relay box. Be careful not to catch the engines dipstick.
3. You will notice a small notch at the pointed side of your new cover. This
notch is designed to hook into the radiator shroud. This can be achieved by
pulling the shroud forward, which will create clearance for the notch to
engage. It will hook to the side of the radiator shroud. Then gently position
the point of the new cover down slightly to lock in place.
4. You have been provided with a long black sheet metal screw and a 9/64
th
cobalt drill bit. Locate the small tab at the rear of your new cover and pull it
up to the gasket ridge and hold firmly. Make note of the covers position
around the fuse box and adjust so that there is an even amount of space all
around it. Once you are satisfied with its position drill a small hole thru the
gasket ridge directly into the new covers tab area. Be sure to hold in position
firmly. Once this is complete blow off any metal shavings. BE CAREFUL
THESE CAN SCRATCH YOUR NEW COVER.
5. Carefully remove protective liner. Once the panel has been uncovered simply
insert the long black washer head screw thru the hole you’ve created in the
gasket ridge and into the cover. Be careful not to over tighten.
6. (Fuse box relay cover) You will notice a large tab on the side of this small
cover. Test fit the cover so that the tab fits thru the notch in the large cover,
so that the cover has about a 1/16
th”
gap at the right side of the tab and left
side of the cover. Holding it in position unlatch the factory lid and test its
motion opening and closing. Adjust position of this cover so that it opens and
closes freely and make note of the position. Once you are satisfied remove the
new cover then remove the red liner from the attachment tape on the
underside of the cover and reposition and press firmly to set. You should be
able to latch open and close and re-latch without obstruction. Note: This is a
permanent installation! When it comes time to remove your large cover
simply unsnap the factory fuse box cover with the small cover attached to
allow removal of the large cover.
7. Your driver’s side cover can be installed in exactly the same way as the
passengers cover (see steps 1-5) only you must remove all fill caps.
8. Once your cover is in place replace all fill caps. Then remove the protective
liner. Replace your wiper cowl gasket. You have been provided with two
large Velcro attachment pads. Remove liner and place these on top of the
previously treated water and brake fluid caps. Press firmly to set.