American Car Craft Challenger_Charger_Magnum_300 SRT 8 5.7L_6.4L MOPAR Cold Air Intake Cover Clear_Polished 2011-2013 User Manual

American car craft instructions

Advertising
background image

AMERICAN CAR CRAFT INSTRUCTIONS

CHALLENGER SRT 8/5.7 MOPAR COLD AIR BOX FILTER CUSTOM TOP PLATE

PART #153030

PARTS INCLUDED:
1-Plastic Cover w/Velcro
1-Small Scratch Pad
1-Adhesive Promoter Pack
1-32.5” Length Of Furry Velcro
1-Large 1.25 Washer Head Type Bolt, Nut and Washer
1-Decorative Chrome Cap w/Butyl Putty

INTORDUCTION: This new accessory is a unique and stylish part designed to add an awesome custom look to what
otherwise would be a relatively unattractive air filter box. Please note that the cover is strictly decorative and is not
intended to seal the factory air box.

PROTECTIVE LINER INFORMATION: Your new accessories will come to you with a protective surface liner. Leave this
liner in place until the installation is complete to prevent finger prints and/or possible scratches during installation.

1. The first step for this installation will be to prepare the air box to receive the new accessory by removing the

rubber gasket attached to the air box top ridge. (Note: This gasket will not be reused).

2. You will notice that the air box is fastened to the vehicle with one single bolt located at the top front area of

the box and that this bolt has been sleeved with a steel sleeve encapsulated with a rubber grommet. Remove
this bolt. Then remove the rubber grommet from the air box. (Note: This grommet will not be reused).

Advertising