American Car Craft Challenger_Charger_Magnum_300 SRT 8 5.7L_6.4L MOPAR Cold Air Intake Cover Clear_Polished 2011-2013 User Manual
Page 4
7
9. Now you are ready to install your new cover. You will notice that your new cover has Velcro attached to the
underside of the covers frame and the window is slightly elevated. Remove the protective liner from the
window and then place the frame so that the window will set into the air box ridge allowing the Velcro to
seat the window securing it in place. Although it should not be necessary you may need to tweak the shape
of the top cove a little in order to achieve a nice contoured fit.
10. Remove the remaining protective liner. You have been provided with a large 1.25” Washer head type bolt nut
and washer. This bolt has been proved as a replacement bolt for the factory one. Depending on the
production date of your Challenger this new bolt may slip through the existing welded nut at the front of the
air box, in which case we have provided a new nut and washer to be placed under the factory tab allowing
you to secure the new cover’s mounting tab. Then simply cover the new bolt head with the decorative
chrome cap cover. This cover will have a butyl putty attached, simply remove the release tape and press it
onto the bolt head to finish the installation. (Note: Some Challenger models use a smaller bolt and nut to
secure the air box.) If this is the case you can elect to either drill the factory bolt with a ¼” drill bit to allow
the new bolt to be set through the factory nut (recommended) or you can use the original bolt to secure the
new cover or you can re-tap the factory nut with a ¼” 20 taping bit.
If you have any questions during installation please call American Car Craft at 727 861-1500.
Thank you and enjoy your new purchase!
AMERICAN CAR CRAFT
18924 SAKERA RD HUDSON FL 34667
Phone: 727 861-1500 Fax: 727 861-1520