American Car Craft Challenger_Charger_Magnum_300 SRT 8 5.7L_6.4L MOPAR Cold Air Intake Cover Clear_Polished 2011-2013 - Manual (Page 3)

5
7. Once these procedures are complete, you can now set up the top ridge for the new cover. You have been
provided with a small piece of scratch pad. Use this pad to thoroughly scuff the outer and inner sides of the
upper ridge that runs along the entire circumference of the air box. SEE PICTURE 6.
6
8. Once this is done scrub the ridge with rubbing alcohol to remove the dust and also to clean the ridge. Then
swipe both the inner and outer sides of the ridge with the adhesive promoter packet provided. This packet is
NOT a cleaner but and an adhesive accelerator and must be used as such in order to successfully and
permanently attach the 32.5” length of furry Velcro supplied with your kit. Once the ridge is prepared, peel
the release liner completely from the Velcro strip and place the end of the strip along the ridge, starting at
the front left side and then along the entire box until you reach the other end. Trim away any excess if
necessary. At this point the Velcro will be standing straight up on the ridge and you can now fold the Velcro
over the ridge to the inside of the box. (Tech Note: Before you fold the Velcro over, slit the Velcro at all four
corners with a razor blade. This will allow you to fold the Velcro more easily and eliminate wrinkles in the
process.) Press firmly along the entire ridge to set the bond of the Velcro. SEE PICTURE 7.