Peerless-AV HDS-OWRE-200 - Installation - Manual (Page 16)

16 of 22 ISSUED: 08-24-12 SHEET #: 180-9030-1
Open the wireless receiver enclosure (A) and remove the sub panel assembly as shown in fi g. 8.1. Loosely attach
the small enclosure mounting brackets (J) to the wireless receiver enclosure (A) with two 1/4-20 x 1/2 socket
head screws (G) and two 1/4-20 nuts (H) as shown in fi g. 8.2. NOTE: The enclosure mounting bracket can be
installed with the inside notch facing downward if additional side-to-side adjustment is needed. Position and
tighten the four 1/4-20 x 1/2 socket head screws (G) using 4mm allen wrench (L). Press in two plastic plugs (F)
into holes shown in fi gure 8.2.
8
Enclosure Installation to EPT650 Tilt Wall Mount
fi g. 8.1
fi g. 8.2
A
F
J H
G
SUB PANEL
ASSEMBLY
INSIDE NOTCH
Attach the mounting brackets (J), open end of notch facing downward, to the left tilt bracket with two
1/4-20 x 1/2 socket head screws (G) and two 1/4-20 nuts (H) as shown in fi g. 9.1. Adjust the position of the
enclosure (A) to your desired location and tighten the four 1/4-20 x 1/2 socket head screws (G) using 4mm allen
wrench (L). 9
fi g. 9.1
H
A
G
LEFT TILT BRACKET