Peerless-AV HDS-OWRE-200 - Installation - Manual (Page 19)

19 of 22 ISSUED: 08-24-12 SHEET #: 180-9030-1
TRIPLE TAP
GROUNDED OUTLET
TRIPLE TAP
GROUNDED
OUTLET
EXTENSION CORD
CORD ACCESS
HOLE
WIRELESS
RECEIVER POWER
ADAPTER
FOAM PADS
Plug in the wireless receiver power adapter into the triple tap grounded outlet as shown. Insert an extension cord
(not included) through the cord access hole in the bottom of the enclosure as shown. Plug entension cord into the
triple tap grounded outlet. Insert the sub panel assembly into the wireless receiver enclosure (A) above the foam
pads as shown. Push the sub panel assembly down and towards the rear of the until it makes contact with the
back wall and the bottom of the enclosure. 11
A
SUB PANEL
ASSEMBLY
Wireless Receiver Setup (Receiver Not Included)