Peerless-AV HDS-OWRE-200 - Installation - Manual (Page 17)

17 of 22 ISSUED: 08-24-12 SHEET #: 180-9030-1
To prevent scratching the display, set a cloth on a fl at, level surface that will support the weight of the display. Place
display face side down. If display has knobs on the back, remove them to allow the adapter brackets to be at-
tached. Place adapter brackets on back of display, align to holes, and center on back of display as shown below.
Attach the adapter brackets to the back of the display using the appropriate combination of screws, multi-washers,
and spacers as shown in fi gure 10.1.
NOTE: "X" dimensions should be equal.
CENTER BRACKETS
VERTICALLY ON BACK
OF DISPLAY
X
X
TILT LOCKING SCREWS
FACE OUT
10
Notes:
• The number of fasteners used will vary,
depending upon the type of display.
• Multi-washers and spacers may not
be used, depending upon the type of
display.
• Use the corresponding hole in the multi-
washer that matches your screw size as
shown.
MEDIUM HOLE FOR M5 SCREWS
SMALL HOLE FOR M4 SCREWS
LARGE HOLE FOR M6 SCREWS
MULTI-WASHER
Installing Tilt Brackets
NOTE: Top and bottom mounting holes on display must be used for attaching brackets.
NOTE: Be sure to attach tilt brackets with tilt locking screws facing outward as shown below. Verify that all holes
are properly aligned, and then tighten screws using a phillips screwdriver.
• Tighten screws so adapter brackets are fi rmly attached. Do not tighten with excessive force. Overtightening
can cause stress damage to screws, greatly reducing their holding power and possibly causing screw heads to
become detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the display inserts or if screws bottom out and bracket is still not tightly
secured, damage may occur to display or product may fail.
WARNING