Peerless-AV HDS-IWK-200 - Installation - Manual (Page 19)

19 of 24 ISSUED: 08-23-12 SHEET #: 180-9027-2 10-30-12
Installation to Adapter Plate with VESA 200 or 200 x 100 Mounting Pattern
A A
Position the adapter plate on the back of the display.
Position the wireless receiver assembly (A) and power
module assembly (B) over the adapter plate. Attach
adapter plate and assemblies (A and B) to back of display
using four M4 screws from the baffl ed fastener pack as
shown below. Continue to step 5. Position the adapter plate on the back of the display.
Position the wireless receiver assembly (A) and power
module assembly (B) over the adapter plate. Attach
adapter plate and assemblies (A and B) to back of display
using four M6 or M8 screws from the baffl ed fastener pack
as shown below. Continue to step 5.
B B
FOR VESA 200 MOUNTING PATTERN USING M4
SCREWS: FOR VESA 200 MOUNTING PATTERN USING
M6 OR M8 SCREWS:
FOR VESA 200 x 100 MOUNTING PATTERN:
Remove adapter plate from mount. Choose hole pattern as shown below. Position the adapter plate on the back
of the display. Position the wireless receiver assembly (A) and power module assembly (B) over the adapter
plate. Attach adapter plate and assemblies (A and B) to back of display using four M4 or M6 screws from the
baffl ed fastener pack as shown below. Continue to step 5.
• Tighten screws so tilt brackets are fi rmly attached. Do not tighten with excessive force. Overtightening can cause
stress damage to screws, greatly reducing their holding power and possibly causing screw heads to become
detached. Tighten to 40 in. • lb (4.5 N.M.) maximum torque.
• If screws don't get three complete turns in the display inserts or if screws bottom out and tilt bracket is still not
tightly secured, damage may occur to display or product may fail.
WARNING
4-1
B
A ADAPTER PLATE
ADAPTER PLATE ADAPTER
PLATE