Peerless-AV HDS-IWK-200 - Installation - Manual (Page 8)

8 of 24 ISSUED: 08-23-12 SHEET #: 180-9027-2 10-30-12
NOTE: Wireless Receiver and Power Box
removed for clarity.
Begin with the longest length screw, hand thread
screw through multi-washer, display brackets and
spacer in that order into display as shown below.
Screw must make at least three full turns into the
mounting hole and fi t snug into place. Do not over
tighten. If screw cannot make three full turns into
the display, select a shorter length screw from
the baffl ed fastener pack. Repeat for remaining
mounting holes, level display brackets and tighten
screws.
1-6
1-7
DISPLAY
MULTI-WASHER
SPACER
B
SCREW
Center display brackets horizontally and
vertically on back of display. Tighten two 1/4-20
x 1.25" screws. Reinstall four 1/4-20 x .6" screws
using a 5 mm allen wrench into appropriate
fi xed-stop position from chart on page 5.
Skip to step 5.
1/4-20 x 1.25" SCREWS
1/4-20 x .6" SCREWS