Peerless-AV HDS-IWK-200 - Installation - Manual (Page 20)

20 of 24 ISSUED: 08-23-12 SHEET #: 180-9027-2 10-30-12
Wireless Receiver Assembly and Power Module Assembly Setup
Remove the two #8 screws securing the cover of the wireless receiver assembly as shown in detail 3. Open the
enclosure to expose the wireless receiver and IR receiver. Remove the two M5 x 10mm phillips screws and open
the power enclosure as shown in detail 4. 5
DETAIL 3 DETAIL 4
#8 SCREW
M5 x 10mm SCREWS
NOTE: The following steps explain how to setup the wireless receiver assembly (A) and power module assembly
(B) showing the universal adapter plate. The same steps will be used for tilt bracket, large plp, and VESA 200
adapter plate installations unless otherwise specifi ed.
Untie the wireless receiver power adapter cord and route as shown below. Plug the end of the power adapter into
the outlet marked DC on the wireless receiver as shown in detail 5. Coil up the excess cord and secure with a
cable tie (F). Store the coiled cord between the power adapter and the power module wall as shown. 6
DC
LAN
USB
DETAIL 5
WIRELESS RECEIVER POWER
ADAPTER
DISPLAY NOT
SHOWN FOR
CLARITY