Peerless-AV HDS-IWK-200 - Installation - Manual (Page 21)

21 of 24 ISSUED: 08-23-12 SHEET #: 180-9027-2 10-30-12
Locate the IR receiver inside of the wireless receiver enclosure shown in fi gure 7.1. Remove the tie from the cable
and position the receiver on the display within line of sight of your remote as shown in fi gure 7.2. Remove the
adhesive backing from the IR receiver eye and attach to the display. Coil up the excess cord near the wireless
receiver enclosure and secure with a cable tie (F). Store the coiled cord back inside of the enclosure. 7
IR RECIEVER
fi g. 7.1
fi g. 7.2
IR RECIEVER
Close the top cover of the wireless receiver enclosure, making sure that the IR receiver cord runs underneath the
cable opening as shown in fi gure 8.1. Re-install the two #8 screws. 8
CABLE OPENING
#8 SCREWS
fi g. 10.1