Warning – Peerless-AV HDS-IWK-200 - Installation User Manual
Page 23
23 of 24
ISSUED: 08-23-12 SHEET #: 180-9027-2 10-30-12
© 2012 Peerless Industries, Inc.
Peerless-AV® is a registered trademark of Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
Plug extension cord into power source and route cords to allow full operation of your mount.
To complete the installation of your wireless system, please refer to the HD Flow™ User's Manual and the HD
Flow™ Install Guide included.
Universal Adapter Plate, Large PLP, or VESA 200 Adapter Plate - Re-install adapter plate to mount.
Tilt Bracket - Re-install tilt brackets to wall plate.
• Do not lift more weight than you can handle. Use additional man power or mechanical lifting equipment to safely
handle placement of the display.
• Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten M10 x 15 mm
screws to 40 in. • lb. (4.52 N.M.) maximum torque.
WARNING
16
17
HDMI-
OUT
Plug the component cable(s) from your display
(HDMI shown) into the wireless receiver.
Plug extension cord (not included) into the tripe tap
grounded outlet.
14
15
EXTENSION CORD
COMPONENT
CABLE