Prokit's Industries SS-952B - Manual (Page 7)

6
7 Prepare work before operation
 Select the FP Pick-up Wire, The size of it and IC should
match. FP Pick-up has a small wire (15mm). But it
probably needs a big FP Pick-up wire (20mm) Please
choose the suitable FP Pick-up Wire according to the size
of IC Select the suitable nozzle, which should be matched
with IC in size.
 Loosen the screw of nozzle
 Set up the nozzle according to the graph.
 Tighten the screw properly
8 The process of removing solder.
 Turn on the power switch, temperature displayed is the
required, and the heater start to heat up, the indicator
lamp is glimmering.
 Place the FP pick-up under the IC if the width of IC is not fit
to the steel wire of FP pick-up, steel wire of pick-up, press
the steel wire to fit it.
 Melt the solder holding the iron, aim the nozzle at the solder,
let it melted by the hot Air.
NOTE : Don’t touch the pin of IC with the nozzle.
 To move IC After the solder is melted, use the FP pick-up
move the IC.
 Power off after power down switch is pressed, automatic
blowing is started, to cool down the heating part and the
handle, during this period, don’t unplug the power supply,
when the temperature of muzzle is below 100℃ the machine
will automatically power down, if the machine will not be
used in long time, unplugging the power supply is
suggested.
 Clean the remained solder after the IC is moved, the
remained solder could be cleaned by solder absorber or
absorber pump.
9. Soldering

Lay on some soldering paste, place the SMD on board.
 Pre-heating the SMD.