Prokit's Industries SS-952B - Manual (Page 8)

7
 Joining evenly blow the hot air to leads.
 Cleaning After jointing is finished, clean the remaining solder
NOTE: its effect to joint by hot air, but it is also possible lead
to the problem of solder link or solder ball, we advice you
to check it carefully.
NOTE:
 Don’t overexert while fixing muzzle, or pull the muzzle with
forceps, or screw breech block too tightly.
 Be careful, working with high temperature. Don’t use this
product near flammable gas, paper, or other flammable
things. The temperature of muzzle and hot air is very high
and could be hurt, don’t touch the heating part or blow the
hot air to body. If the machine is new, due to heat instruction
material build in it’s handle, it will smoke in a short time, and
this is normal. After using does remember cooling down the
machine, after power down is pressed, the machine
automatic cool down by blowing during this period, please
keep power on.
 Never drop or sharply jolt the unit. The pipe contains quartz
glass, which can break if the unit dropped or jolted sharply.
 Do not disassemble the pump.
 Disconnect the plug when you don’s use the unit for a long
time.
 When the temperature is over 350℃, the temperature
setting button had better set between level 3 to 8 while
turning on the machine.
10. How to use suction pen
1) Based on the need to extract weight (less than 100g) and
surface size, Select the sucker size, installed in the suction
pen head.
2) Put the sucker horizontally on the surface of the adsorbed
item. Close the hole on the pen with one hand, The suction
pen will hold items
3) Move the absorbed item to the position wanted, open the
holes on the suction pen, Items out of sucker