Dexter Laundry T-50X2 EXPRESS (Commercial) - Manual (Page 10)

TO CHANGE PROGRAMMED VALUES OR ZERO REGISTERS
1. Open both the upper and lower loading doors.
2. Unlock the control tray, carefully slide the control tray assembly forward about three inches. Press the program
switch. (See fig. 4 “Top View of Controller”) Reinstall and lock the controller.
The controller is now in the program mode at the “00” step, displaying the hours run by the lower drum. (Refer
to the table defining the steps.)
This value displayed can be reset to “0” or observed and left as is. Pressing the lower hot or high switch will advance
the controller through the eighteen remaining steps allowing observation or alteration.
Note that on any program change or reset it is necessary to advance to the next step by pressing the lower hot
or high switch to enter the revision. Otherwise the value will remain as it was before the alteration.
FIGURE 4 - Top View Of Controller.
10