Factory Direct Hardware Hansgrohe 10135 - Manual (Page 3)

3
• Thread on the escutcheons with o-
rings. Install the red and blue color
rings. Install the white plastic handle
snap connectors with the screws.-
Press the handle firmly over the snap
connector and push firmly
downwards.
• Seat the spout assembly with sealing
ring on top of the mounting surface.
From below, thread on the fiber
washer, metal washer, and mounting
nut.
• Make sure that the spout assembly
stands straight. Tighten the
tensioning screws.
• Use the 9/16" compression fittings to
install the connection hoses to the
valve outlets.
• Connect the valves to the angle stops
with ½” supply hoses and nuts.
(Hansgrohe does not provide angle
stops, supply hoses, or nuts.)