Install the pop-up drain – Factory Direct Hardware Hansgrohe 10135 User Manual
Page 4
4
Install the pop-up drain:
•
Remove the plunger assembly.
•
Unscrew the drain outlet flange from the tee.
•
Unscrew the tailpiece from the tee. Wrap the threads with plumbers’ thread tape
and replace.
•
Install the white, flexible sealing gasket to the flange. Sit it in the sink outlet.
•
From under the sink, install the black mack gasket, white friction ring , and retainer
nut to the flange. Do not tighten the nut against the bottom of the sink at this time.
•
Thread the tee and tailpiece to the flange. The pivot must face the faucet. If
necessary, turn the drain assembly.
•
Tighten the retainer nut.
•
Sit the plunger assembly in the drain.
•
Install the horizontal rod so that the end goes through the loop in the bottom of the
height adjuster.
•
Install and hand tighten the pivot ball nut.
•
Attach the swivel connector to the end of the horizontal rod.
•
Attach the swivel connector to the end of the vertical rod. Position as desired, and
tighten with a small, flathead screwdriver.