Factory Direct Hardware Hansgrohe 17010 - Manual (Page 2)


Technical Specification
Hole size in mounting surface
Minimum 1-3/8” Maximum 1-5/8”
Maximum mounting surface depth 1-1/4”
Flow rate . GPM
Maximum operating pressure 145 PSI
Recommended operating pressure  - 7.5 PSI
Recommended hot water temp 10 o - 140 o F*
M3 cartridge with Boltic TM handle screw
*Some governing bodies require that the water heater be set to 10 o F or
less. Please know and follow all local codes when setting the temperature
on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends installation by a licensed professional plumber.
• Large differences in pressure between the hot and cold supplies should be balanced.
• The supply hoses on this faucet require supply stops with 3/8” compression fittings (not included).
• This faucet has a high temperature limit stop. It ships from the factory on the maximum setting, but may
be reset to a lower temperature if desired.
Axor Carlton Single Control Lavatory Faucet
17010XX1